R3166-R3206-HP High-End Firewalls High Availability Configuration Guide-6PW101

78
Configuring optional parameters for an NQA test
group
Optional parameters for an NQA test group are valid only for tests in this test group.
Unless otherwise specified, the following optional parameters are applicable to all test types.
Follow these steps to configure optional parameters for an NQA test group:
To do… Use the command…
Remarks
Enter system view system-view —
Enter NQA test group view
nqa entry admin-name
operation-tag
—
Enter test type view of a
test group
type { dhcp | dlsw | dns |
ftp | http | icmp-echo |
snmp | tcp | udp-echo |
udp-jitter | voice }
—
Configure the description
for a test group
description text
Optional
By default, no description is available for a test
group.
Configure the interval
between two consecutive
tests for a test group
frequency interval
Optional
By default, the interval between two consecutive
tests for a test group is 0 milliseconds. Only one
test is performed.
If the last test is not completed when the interval
specified by the frequency command is reached,
a new test does not start.
Configure the number of
probe operations to be
performed in one NQA
test
probe count times
Optional
By default, one probe operation is performed in
one test.
Not available for voice tests, Only one probe
operation can be performed in one voice test.
Configure the NQA probe
timeout time
probe timeout timeout
Optional
By default, the timeout time is 3000 milliseconds.
This parameter is not available for a UDP jitter test.
Configure the maximum
number of hops a probe
packet traverses in the
network
ttl value
Optional
20 by default.
Not available for DHCP tests.
Configure the ToS field in
an IP packet header in an
NQA probe packet
tos value
Optional
0 by default.
Not available for DHCP tests.
Enable the routing table
bypass function
route-option bypass-route
Optional
Disabled by default.
Not available for DHCP tests.