Manualshelf

R3166-R3206-HP High-End Firewalls Network Management Command Reference-6PW101

ManualsBrandsHP ManualsComputer AccessoriesHP 7100/7200 IPsec dl Module
211212213214215216217218219220
Table Of Contents
206
Description
Use the network command to enable RIP on the interface attached to the specified network.
Use the undo network command to disable RIP on the interface attached to the specified network.
RIP is disabled on an interface by default.
RIP runs only on the interfaces attached to the specified network. For an interface not on the specified
network, RIP neither receives/sends routes on it nor forwards interface route through it. Therefore, you
must specify the network after enabling RIP to validate RIP on a specific interface.
For a single process, you can use the network 0.0.0.0 command to enable RIP on all interfaces, while
the command is not applicable in case of multi-process.
If a physical interface is attached to multiple networks, you cannot advertise these networks in different
RIP processes.
Examples
# Enable RIP on the interface attached to the network 129.102.0.0.
<Sysname> system-view
[Sysname] rip 100
[Sysname-rip-100] network 129.102.0.0
output-delay
Syntax
output-delay time count count
undo output-delay
View
RIP view
Default level
2: System level
Parameters
time: RIP packet sending interval, in milliseconds. It is in the range 10 to 100.
count: Maximum number of RIP packets sent at each interval. It is in the range 1 to 20.
Description
Use the output-delay command to configure the maximum RIP packets that can be sent at the specified
interval for all interfaces under the RIP process.
Use the undo output-delay command to restore the default.
By default, an interface sends up to three RIP packets every 20 milliseconds.
Examples
# Configure all the interfaces under RIP process 1 to send up to 10 RIP packets every 30 milliseconds.
<Sysname> system-view
[Sysname] rip 100
[Sysname-rip-1] output-delay 30 count 10