R3166-R3206-HP High-End Firewalls Network Management Command Reference-6PW101

267
Default level
2: System level
Parameters
None
Description
Use the ospf packet-process prioritized-treatment command to enable OSPF to give priority to receiving
and processing Hello packets.
Use the undo ospf packet-process prioritized-treatment command to restore the default.
By default, this function is not enabled.
Examples
# Enable OSPF to give priority to receiving and processing Hello packets.
<Sysname> system-view
[Sysname] ospf packet-process prioritized-treatment
ospf timer dead
Syntax
ospf timer dead seconds
undo ospf timer dead
View
Interface view
Default level
2: System level
Parameters
seconds: Dead interval in seconds, in the range 1 to 2147483647.
Description
Use the ospf timer dead command to set the dead interval.
Use the undo ospf timer dead command to restore the default.
The dead interval defaults to 40s for Broadcast, P2P interfaces and defaults to 120s for P2MP and
NBMA interfaces.
If an interface receives no hello packet from a neighbor within the dead interval, the interface considers
the neighbor down. The dead interval on an interface is at least four times the hello interval. Any two
routers attached to the same segment must have the same dead interval.
Related commands: ospf timer hello.
NOTE:
This configuration is not supported on the null interface.
Examples
# Configure the dead interval on the current interface as 60 seconds.
<Sysname> system-view