R3166-R3206-HP High-End Firewalls Network Management Command Reference-6PW101

268
[Sysname] interface gigabitethernet 0/0
[Sysname-GigabitEthernet0/0] ospf timer dead 60
ospf timer hello
Syntax
ospf timer hello seconds
undo ospf timer hello
View
Interface view
Default level
2: System level
Parameters
seconds: Hello interval in seconds, in the range 1 to 65535.
Description
Use the ospf timer hello command to set the hello interval on an interface.
Use the undo ospf timer hello command to restore the default hello interval on an interface.
The hello interval defaults to 10s for P2P and Broadcast interfaces, and defaults to 30s for P2MP and
NBMA interfaces.
The shorter the hello interval is, the faster the topology converges and the more resources are consumed.
Make sure the hello interval on two neighboring interfaces is the same.
Related commands: ospf timer dead.
NOTE:
This configuration is not supported on the null interface.
Examples
# Configure the hello interval on the current interface as 20 seconds.
<Sysname> system-view
[Sysname] interface gigabitethernet 0/0
[Sysname-GigabitEthernet0/0] ospf timer hello 20
ospf timer poll
Syntax
ospf timer poll seconds
undo ospf timer poll
View
Interface view
Default level
2: System level