R3166-R3206-HP High-End Firewalls Network Management Command Reference-6PW101

368
View
PBR policy node view
Default level
2: System level
Parameters
interface-type interface-number: Specifies an interface.
track track-entry-number: Specifies a track entry. The track-entry-number argument is in the range 1 to
1024.
Description
Use the apply default output-interface command to set the default outgoing interface.
Use the undo apply default output-interface command to remove the configuration.
Using this command can set two outgoing interfaces at most for load sharing.
For a non-P2P outgoing interface (broadcast and NBMA interfaces) such as Ethernet or virtual-template
interface, multiple next hops are possible, and thus packets may not be forwarded successfully.
Using the undo apply default output-interface command with an interface specified removes the default
outgoing interface. Using this command without any interface specified removes all default outgoing
interfaces.
Examples
# Set the default outgoing interface to GigabitEthernet0/2.
<Sysname> system-view
[Sysname] policy-based-route aa permit node 11
[Sysname-pbr-aa-11] apply default output-interface GigabitEthernet 0/2 track 1
apply ip-address default next-hop
Syntax
apply ip-address default next-hop ip-address [ track track-entry-number ] [ ip-address [ track
track-entry-number ] ]
undo apply ip-address default next-hop [ ip-address [ ip-address ] ]
View
PBR policy node view
Default level
2: System level
Parameters
ip-address: IP address of the default next hop.
track track-entry-number: Specifies a track entry. The track-entry-number argument is in the range 1 to
1024.
Description
Use the apply ip-address default next-hop command to set the default next hop(s).
Use the undo apply ip-address default next-hop command to remove the configuration.