R3166-R3206-HP High-End Firewalls Network Management Command Reference-6PW101

415
Examples
# Set the startup query interval to 5 seconds on GigabitEthernet 0/1.
<Sysname> system-view
[Sysname] interface GigabitEthernet 0/1
[Sysname-GigabitEthernet0/1] igmp startup-query-interval 5
igmp static-group
Syntax
igmp static-group group-address [ source source-address ]
undo igmp static-group { all | group-address [ source source-address ] }
View
Interface view
Default level
2: System level
Parameters
group-address: Multicast group address, in the range of 224.0.1.0 to 239.255.255.255.
source-address: Multicast source address.
all: Specifies to remove all static multicast groups that the current interface has joined.
Description
Use the igmp static-group command to configure the current interface to be a statically connected
member of the specified multicast group or multicast source and group.
Use the undo igmp static-group command to restore the system default.
By default, an interface is not a static member of any multicast group or multicast source and group.
If the specified multicast address is in the SSM multicast address range, you must specify a multicast
source address at the same time; otherwise IGMP routing table entries cannot be established. There is no
such a restriction if the specified multicast group address is not in the SSM multicast address range.
Examples
# Configure GigabitEthernet 0/1 to be a statically connected member of multicast group 224.1.1.1.
<Sysname> system-view
[Sysname] interface GigabitEthernet 0/1
[Sysname-GigabitEthernet0/1] igmp static-group 224.1.1.1
# Configure GigabitEthernet 0/1 to be a statically connected member of multicast source and group
(19 2.168 .1.1, 23 2.1.1.1) .
<Sysname> system-view
[Sysname] interface GigabitEthernet 0/1
[Sysname-GigabitEthernet0/1] igmp static-group 232.1.1.1 source 192.168.1.1
igmp timer other-querier-present
Syntax
igmp timer other-querier-present interval