R3166-R3206-HP High-End Firewalls Network Management Command Reference-6PW101

45
# Assign the hybrid Layer 2 aggregate interface Bridge-Aggregation 1 and its member ports to VLAN 2,
and configure them to send packets of VLAN 2 with tags removed.
<Sysname> system-view
[Sysname] interface bridge-aggregation 1
[Sysname-Bridge-Aggregation1] port link-type hybrid
[Sysname-Bridge-Aggregation1] port hybrid vlan 2 untagged
Please wait... Done.
Configuring GigabitEthernet0/1... Done.
Configuring GigabitEthernet0/2... Done.
Configuring GigabitEthernet0/3... Done.
The output shows that GigabitEthernet 0/1, GigabitEthernet 0/2, and GigabitEthernet 0/3 are the
member ports of the aggregation group corresponding to Bridge-Aggregation 1.
port link-type
Syntax
port link-type { access | hybrid | trunk }
undo port link-type
View
Ethernet interface view, Layer 2 aggregate interface view
Default level
2: System level
Parameters
access: Configures the link type of a port as access.
hybrid: Configures the link type of a port as hybrid.
trunk: Configures the link type of a port as trunk.
Description
Use the port link-type command to configure the link type of a port.
Use the undo port link-type command to restore the default link type of a port.
By default, any port is an access port.
The configuration made in Ethernet view applies only to the port.
The configuration made in Layer 2 aggregate interface view applies to the aggregate interface and its
aggregation member ports.
• If the system fails to apply the configuration to the aggregate interface, it stops applying the
configuration to aggregation member ports.
• If the system fails to apply the configuration to an aggregation member port, it skips the port and
moves to the next member port.
To change the link type of a port from trunk to hybrid or vice versa, you must first set the link type to
access.
After you change the link type of an interface with the port link-type command, the loopback detection
action configured on the interface with the loopback-detection action command automatically restores
the default.