R3166-R3206-HP High-End Firewalls Network Management Command Reference-6PW101

68
undo region-name
View
MST region view
Default level
2: System level
Parameters
name: Specifies the MST region name, a string of 1 to 32 characters.
Description
Use the region-name command to configure the MST region name.
Use the undo region-name command to restore the default MST region name.
By default, the MST region name of a device is its MAC address.
The MST region name, the VLAN-to-instance mapping table, and the MSTP revision level of a device
determine the device's MST region.
After configuring this command, run the active region-configuration command to activate the configured
MST region name.
Related commands: instance, revision-level, vlan-mapping modulo, display stp region-configuration,
check region-configuration, and active region-configuration.
Examples
# Set the MST region name of the device to hello.
<Sysname> system-view
[Sysname] stp region-configuration
[Sysname-mst-region] region-name hello
reset stp
Syntax
reset stp [ interface interface-list ]
View
User view
Default level
1: Monitor level
Parameters
interface interface-list: Clears the MSTP statistics of the ports specified in the format of interface-list =
{ interface-type interface-number [ to interface-type interface-number ] }&<1-10>, where &<1-10>
indicates that you can specify up to 10 ports or port ranges.
Description
Use the reset stp command to clear the MSTP statistics.
The MSTP statistics includes the numbers of TCN BPDUs, configuration BPDUs, RST BPDUs and MST
BPDUs sent/received through the specified ports.