Manualshelf

R3166-R3206-HP High-End Firewalls Network Management Command Reference-6PW101

ManualsBrandsHP ManualsComputer AccessoriesHP 7100/7200 IPsec dl Module
919293949596979899100
Table Of Contents
81
Use the undo stp port priority command to restore the default.
By default, the port priority is 128.
Configured in Ethernet interface view, the setting takes effect on the interface only.
Configured in Layer 2 aggregate interface view, the setting takes effect only on the aggregate interface.
Configured on a member port in an aggregation group, the setting takes effect only after the port leaves
the aggregation group.
To set the priority of an MSTP port in a specific MSTI, use this command with the MSTI specified. To set
the priority of an MSTP port in the CIST or an STP or RSTP port, use this command without specifying any
MSTI .
Port priority affects the role of a port in a spanning tree.
The smaller the value, the higher the port priority. If all ports on your device use the same priority value,
the port priority depends on the port index. The smaller the index, the higher the priority.
Related commands: display stp.
Examples
# In MSTP mode, set the priority of port GigabitEthernet 0/3 to 16 in MSTI 2.
<Sysname> system-view
[Sysname] interface GigabitEthernet 0/3
[Sysname-GigabitEthernet0/3] stp instance 2 port priority 16
stp priority
Syntax
stp [ instance instance-id ] priority priority
undo stp [ instance instance-id ] priority
View
System view
Default level
2: System level
Parameters
instance instance-id: Sets the priority of the device in a MSTI. The value of instance-id ranges from 0 to
15, where 0 represents the CIST.
priority: Specifies a device priority, ranging from 0 to 61440 in steps of 4096 (as in 0, 4096, 8192). You
can set up to 16 priority values on the device. The smaller the value, the higher the device priority.
Description
Use the stp priority command to set the priority of the device.
Use the undo stp priority command to restore the default priority.
By default, the device priority is 32768.
To set the priority of an MSTP device in a specific MSTI, use this command with the MSTI specified. To set
the priority of an MSTP device in the CIST or an STP or RSTP device, use this command without specifying
any MSTI.