R3166-R3206-HP High-End Firewalls Network Management Configuration Guide-6PW101

115
Figure 55 Configure a static address pool
• Type static-pool for IP Pool Name.
• Type 10.1.1.5 for IP Address.
• Select 255.255.255.128 for Mask.
• Type 000f-e200-0002 for Client MAC Address.
• Type 1 0 .1.1.12 6 for Gateway Address.
• Type 10.1.1.2 for DNS Server Address.
• Click Apply.
# Enable the DHCP server on GigabitEthernet 0/1. With DHCP enabled, interfaces work in the DHCP
server mode.
• In the Interface Configuration field, click the icon next to GigabitEthernet 0/1, and perform the
following operations, as shown in Figure 56.
Figure 56 Enable the DHCP server on
an interface
• On the DHCP Server Interface Config page, click on the Enable radio button.
• Click Apply.
Dynamic IP address assignment configuration example
1. Network requirements
• As shown in Figure 57, the D
HCP server (Firewall A) assigns IP address to clients on subnet
10 .1.1. 0 / 24 , w h i c h i s s u b n e t t e d i n t o 10 .1.1. 0 / 2 5 a n d 10 .1.1.12 8 / 2 5 .
• The IP addresses of GigabitEthernet 0/1 and GigabitEthernet 0/2 on Firewall A are 10.1.1.1/25
a n d 10 .1.1.12 9 / 2 5 r e s p e c t i v e l y.