R3166-R3206-HP High-End Firewalls Network Management Configuration Guide-6PW101

126
To do… Use the command… Remarks
Specify the IP address of the
primary network calling processor
voice-config ncp-ip ip-address
Required
Not specified by default.
Specify the IP address of the
backup network calling processor
voice-config as-ip ip-address
Optional
Not specified by default.
Configure the voice VLAN
voice-config voice-vlan vlan-id
{ disable | enable }
Optional
Not configured by default.
Specify the failover IP address and
dialer string
voice-config fail-over ip-address
dialer-string
Optional
No failover IP address or dialer
string is specified by default.
NOTE:
Specify an IP address for the network calling processor before performing other configurations.
Configuring the TFTP server and bootfile name for the client
For the DHCP server to support client auto-configuration, you must specify the IP address or name of a
TFTP server and the bootfile name in the DHCP address pool. You do not need to perform any
configuration on the DHCP client.
The DHCP client uses these parameters to contact the TFTP server and request the configuration file used
for system initialization.
1. When a router starts up without loading any configuration file, the system sets an active interface
(such as a Layer 3 Ethernet interface) as the DHCP client to request from the DHCP server for
parameters, such as an IP address and name of a TFTP server, and the bootfile name.
2. After getting related parameters, the DHCP client sends a TFTP request to obtain the configuration
file from the specified TFTP server for system initialization. If the client cannot get such parameters,
it performs system initialization without loading any configuration file.
Follow these steps to configure the IP address and name of the TFTP server and the bootfile name in the
DHCP address pool:
To do… Use the command…
Remarks
Enter system view system-view —
Enter DHCP address pool view
dhcp server ip-pool pool-name
[ extended ]
—
Specify the TFTP server tftp-server ip-address ip-address
Required to use either command
Not specified by default.
Specify the name of the TFTP server
tftp-server domain-name
domain-name
Specify the bootfile name bootfile-name bootfile-name
Required
Not specified by default.