R3166-R3206-HP High-End Firewalls Network Management Configuration Guide-6PW101

7
# View the interface list of Device A on Host A.
• Select Device Management > Interface from the navigation tree.
• View the Status column of the GigabitEthernet 0/1 row.
In this case, is displayed in the Status column of the GigabitEthernet 0/1 row, indicating that
GigabitEthernet has been shut down. You can click the icon to bring up GigabitEthernet 0/1.
# View interface statistics of Device A on Host A.
• Select Device Management > Interface from the navigation tree.
• Click the interface name GigabitEthernet 0/1.
• View information about GigabitEthernet 0/1 in the Interface Statistics text box.
In this case, the state of GigabitEthernet 0/1 is displayed as DOWN in the Interface Statistics text box.
4. Remove an interface
# Remove an interface of Device A on Host A.
• Select Device Management > Interface from the navigation tree.
• Click the icon corresponding to Loopback1.
• Click Apply to complete the operation.
# View the interface list of Device A on Host A.
• Select Device Management > Interface from the navigation tree.
• Fail to find the name of the interface Loopback1.
Managing interfaces in the CLI
General Ethernet interface or subinterface configuration
This section describes the attributes and configurations common to Layer 2 and Layer 3 Ethernet
interfaces. For more information about the attributes and configuration, see “Configuring a Layer 2
Ether
net interface or subinterface” and “Configuring a Layer 3 Ethernet interface or subinterface.”
Configuring a combo interface
A combo interface comprises fiber combo port and a copper combo port. The two ports share one
forwarding interface and cannot work at the same time. If one port is enabled, the other port is
automatically disabled.
Follow these steps to change the active port of a combo interface:
To do… Use the command…
Remarks
Enter system view system-view —
Enter Ethernet interface view
interface interface-type
interface-number
—
Activate the copper combo port or
fiber combo port
combo enable { copper | fiber }
Optional
By default, the copper combo port
is active.
Configuring basic settings of an Ethernet interface
You can set an Ethernet interface to operate in one of the following duplex modes: