R3166-R3206-HP High-End Firewalls Network Management Configuration Guide-6PW101

188
Figure 103 Network diagram for configuring static ARP entries
2. Configuration procedure
# Create VLAN 10.
• Select Network > VLAN > VLAN from the navigation tree, and click Add.
• Type 10 for VLAN ID.
• Click Apply.
# Add GigabitEthernet 0/1 to VLAN 10.
• Click corresponding to VLAN 10 on the VLAN page.
• Set GigabitEthernet 0/1 as an untagged member of VLAN 10.
• Click Apply.
# Create VLAN-interface 10, and configure the IP address of VLAN-interface 10.
• Select Device Management > Interface from the navigation tree, and click Add.
• Set interface name to Vlan-interface 10.
• Select Static Address for IP Config
• Type 192.168.1.2 for IP Address.
• Type 24(255.255.255.0) for Mask.
• Click Apply.
# Create a static ARP entry.
• Select Firewall > ARP Management > ARP Table from the navigation tree and click Add.
• Type 192.168.1.1 for IP Address.
• Type 00
e0-fc01-0000 for MAC Address.
• Select the Advanced Options checkbox.
• Type 10 for VLAN ID.
• Select GigabitEthernet0/1 for Port.
• Click Apply.