R3166-R3206-HP High-End Firewalls Network Management Configuration Guide-6PW101

218
Item Descri
p
tion
ACL
Define an ACL-based match criterion
After selecting the ACL option, you should select or input an ACL number.
The available ACLs are those configured in Firewall > ACL. For more
information about ACL, see Access Control Configuration Guide.
If the specified ACL does not exist, the classifier cannot be applied to the
hardware.
Protocol group Define a criterion to match a protocol group
Source MAC Address
Define a criterion to match a source MAC address
After selecting the Source MAC Address option, you should input a MAC
address.
Note that a criterion to match a source MAC address is applicable only to
Ethernet interfaces.
Destination MAC Address
Define a criterion to match a destination MAC address
After selecting the Destination MAC Address option, you should input a
MAC address.
Note that a criterion to match a destination MAC address is applicable only
to Ethernet interfaces.
Customer 802.1p
Define a criterion to match a customer 802.1p precedence value
After selecting the Customer 802.1p option, you should input customer
802.1p precedence values.
Note that: you can input up to eight 802.1p precedence values, such as 3,
5-7; the logical relationship between different 802.1p precedence values is
OR.
Return to QoS policy configuration task list.
Creating a traffic behavior
Select Firewall > QoS > Behavior from the navigation tree to enter the behavior displaying page, as
shown in Figure 119. C
lick Create to enter the page for creating a behavior, as shown in Figure 120.