R3166-R3206-HP High-End Firewalls Network Management Configuration Guide-6PW101

228
Figure 129 Create a CAR list
Table 50 describes the configuration items of creating a CAR list.
Table 50 Configuration items of creating a CAR list
Item Descri
p
tion
CAR List Index Specify the CAR list index.
IP Type Select to configure a source IP-based CAR list or destination IP-based CAR list.
IP Set
Define the way of specifying a set of IP addresses. Two options are available:
• Subnet: Specifies a network segment by specifying an IP address and a subnet
mask.
• IP Range: Specifies an IP address range by specifying a start IP address and an end
IP address.
IP Address
Specify an IP address and a subnet mask.
The two items are available when you select Subnet from the IP Set drop-down list.
Mask
Start IP Address
Specify a start IP address and an end IP address.
The two items are available when you select IP Range from the IP Set drop-down list.
End IP Address
Limit Rate Per IP
Address
Specify to perform per-IP address rate limiting.
With this function enabled, rate limiting is performed for traffic of each IP address in
the specified IP address set separately. Otherwise, rate limiting is performed for all
traffic of the IP address set.
Shared Bandwidth
Specify that the traffic of all IP addresses in the specified IP address set shares the
remaining bandwidth.
This item is available when you select Enable from the Limit Rate Per IP Address
drop-down list.
Return to Traffic policing configuration task list.