R3166-R3206-HP High-End Firewalls Network Management Configuration Guide-6PW101

240
Item Remarks
Priority Type the static route preference
Static route configuration example
Network requirements
It is required to add a static route, with destination address 1.1.1.1, mask 255.255.255.0, next hop
2.2.2.2, outbound interface GigabitEthernet 0/0, and priority 80.
Configuration procedure
# Add a static route.
• Select Network > Routing Management > Static Routing from the navigation tree and click Add.
• Type 1.1.1.1 as the destination IP address.
• Select 255.255.255.0 from the mask drop-down list.
• Type 2.2.2.2 as the next hop.
• Select GigabitEthernet0/0 from the output interface drop-down list.
• Type 80 as the priority value.
• Click Apply.
• Return to the static route display page and you will see the newly added static route.
Configuring static route in the CLI
Configuration prerequisites
• Configure the physical parameters for related interfaces
• Configure the link-layer attributes for related interfaces
• Configure the IP addresses for related interfaces
Configuration procedure
Follow these steps to configure a static route:
To do… Use the command…
Remarks
Enter system view system-view —