R3166-R3206-HP High-End Firewalls Network Management Configuration Guide-6PW101

248
Figure 140 Network diagram for RIP configuration
Configuration procedure
1. Configure an IP address for each interface and configure security zones (Omitted)
2. Enable RIP
# Configure Device A.
• Select Network > Routing Management > RIP from the navigation tree of Device A.
• Select the Enable RIP(Enable all interfaces automatically) check box, as shown in Figure 141.
• Cl
ick Apply.
Figure 141 Enable RIP
# Configure Device B.
• Select Network > Routing Management > RIP from the navigation tree of Device B.
• Select the Enable RIP(Enable all interfaces automatically) check box, as shown in Figure 141.
• Cl
ick Apply.
Verify the configuration
# Display active routes of Device A.
Select Network > Routing Management > Routing Info from the navigation tree of Device A to display
learned RIP route destined for 10.0.0.0/8, as shown in Figure 142.
Figure 142 RIP configuration result I