R3166-R3206-HP High-End Firewalls Network Management Configuration Guide-6PW101

249
# Display active routes of Device B.
Select Network > Routing Management > Routing Info from the navigation tree of Device B to display
learned RIP routes destined for 2.0.0.0/8 and 3.0.0.0/8, as shown in Figure 143.
Figure 143 RIP configuration result II
Configuring RIP in the CLI
Configuring RIP basic functions
Configuration prerequisites
• Configure the link layer protocol.
• Configure an IP address on each interface, and make sure all adjacent routers are reachable to
each other.
Configuration procedure
1. Enabling RIP and a RIP interface
Follow these steps to enable RIP:
To do… Use the command…
Remarks
Enter system view system-view ––
Enable a RIP process and enter RIP
view
rip [ process-id ] [ vpn-instance
vpn-instance-name ]
Required
Not enabled by default
Enable RIP on the interface
attached to the specified network
network network-address
Required
Disabled by default