R3166-R3206-HP High-End Firewalls Network Management Configuration Guide-6PW101

280
# Display the routing table of Device A.
Select Network > Routing Management > Routing Info from the navigation tree of Device A. The OSPF
routes 3.2.1.0/24, 10.3.1.0/24, 10.4.1.0/24 and 10.5.1.0/24 that are learned after OSPF is enabled
are displayed in the routing table, as shown in Figure 161.
Figure 161 OSPF configur
ation result II
Configuring OSPF in the CLI
OSPF configuration task list
Make a proper plan before configuring OSPF.
To run OSPF in a routing domain, you must first enable OSPF on the routers. Then you can use the default
settings of parameters such as the hello interval, LSA delay timer, and SPF calculation interval. You can
also configure them as needed. OSPF routers should be configured on an area basis. Wrong
configurations may cause communication failures, routing information block, and routing loops.
Complete the following tasks to configure OSPF:
Task Remarks
Enabling OSPF Required
Configuring
OSPF areas
Configuring a stub area
Optional
Configuring an NSSA area
Configuring a virtual link
Configuring
OSPF network
types
Configuring the OSPF network type for an interface as broadcast Optional
Configuring the OSPF network type for an interface as NBMA Optional
Configuring the OSPF network type for an interface as P2MP Optional
Configuring the OSPF network type for an interface as P2P Optional