R3166-R3206-HP High-End Firewalls Network Management Configuration Guide-6PW101

281
Task Remarks
Configuring
OSPF route
control
Configuring OSPF route summarization Optional
Configuring OSPF inbound route filtering Optional
Configuring ABR Type-3 LSA filtering Optional
Configuring an OSPF cost for an interface Optional
Configuring the maximum number of OSPF routes Optional
Configuring the maximum number of load-balanced routes Optional
Configuring OSPF preference Optional
Configuring OSPF route redistribution Optional
Tuning and
optimizing
OSPF networks
Configuring OSPF packet timers Optional
Specifying an LSA transmission delay Optional
Specifying SPF calculation interval Optional
Specifying the LSA arrival interval Optional
Specifying the LSA generation interval Optional
Disabling interfaces from sending OSPF packets Optional
Configuring stub routers Optional
Configuring OSPF authentication Optional
Adding the interface MTU into DD packets Optional
Configuring the maximum number of external LSAs in LSDB Optional
Enabling compatibility with RFC 1583 Optional
Logging neighbor state changes Optional
Configuring OSPF network management Optional
Enabling message logging Optional
Enabling the advertisement and reception of opaque LSAs Optional
Configuring OSPF to give priority to receiving and processing hello
packets
Optional
Configuring the LSU transmit rate Optional
Enabling OSPF
You need to enable OSPF before you can perform other OSPF configuration tasks.
Prerequisites
Configure the link layer protocol and IP addresses for interfaces so that neighboring nodes can
communicate with each other.
Configuration Procedure
To enable OSPF on a router, create an OSPF process and specify areas with which the process is
associated, and the network segments contained in each area. If an interface’s IP address resides on a
network segment of an area, the interface belongs to the area and is enabled with OSPF, and OSPF