R3166-R3206-HP High-End Firewalls Network Management Configuration Guide-6PW101

290
To do… Use the command… Remarks
Enter system view system-view
—
Enter OSPF view
ospf [ process-id | router-id router-id |
vpn-instance instance-name ] *
—
Configure a bandwidth
reference value
bandwidth-reference value
Optional
The value defaults to 100
Mbps.
Configuring the maximum number of OSPF routes
Follow these steps to configure the maximum number of routes:
To do… Use the command…
Remarks
Enter system view system-view
—
Enter OSPF view
ospf [ process-id | router-id router-id |
vpn-instance instance-name ] *
—
Configure the
maximum number of
OSPF routes
maximum-routes { external | inter | intra }
number
Optional
The default value is 500000 for
external routes, 20000 for inter-area
routes, and 2000 for intra-area
routes.
Configuring the maximum number of load-balanced routes
If several routes with the same cost to the same destination are available, configuring them as
load-balanced routes can improve link utilization.
Follow these steps to configure the maximum number of load-balanced routes:
To do… Use the command…
Remarks
Enter system view system-view
—
Enter OSPF view
ospf [ process-id | router-id router-id |
vpn-instance instance-name ] *
—
Configure the maximum number of
equivalent load-balanced routes
maximum load-balancing maximum
Optional
Eight by default
Configuring OSPF preference
A router may run multiple routing protocols, and each protocol is assigned a preference. When the
routing protocols find routes to the same destination, the route found by the protocol with the highest
preference is selected as the best route.
Follow these steps to configure OSPF preference:
To do… Use the command…
Remarks
Enter system view system-view
—
Enter OSPF view
ospf [ process-id | router-id router-id |
vpn-instance instance-name ] *
—