R3166-R3206-HP High-End Firewalls Network Management Configuration Guide-6PW101

297
To do… Use the command… Remarks
Enable OSPF to add the interface
MTU into DD packets
ospf mtu-enable
Optional
Not enabled by default.
Configuring the maximum number of external LSAs in LSDB
Follow these steps to configure the maximum number of external LSAs in the LSDB:
To do… Use the command…
Remarks
Enter system view system-view
—
Enter OSPF view
ospf [ process-id | router-id router-id |
vpn-instance instance-name ] *
—
Specify the maximum number of
external LSAs in the LSDB
lsdb-overflow-limit number
Optional
Not specified by default
Enabling compatibility with RFC 1583
The selection of an external route from multiple LSAs defined in RFC 2328 is different from the one
defined in RFC 1583. If RFC 1583 is made compatible with RFC 2328, the routes in the backbone area
are preferred; if not, the routes in the non-backbone area are preferred to reduce the burden of the
backbone area.
Follow these steps to make them compatible:
To do… Use the command…
Remarks
Enter system view system-view
—
Enter OSPF view
ospf [ process-id | router-id router-id |
vpn-instance instance-name ] *
Required
Make RFC 1583
compatible
rfc1583 compatible
Optional
Compatible by default
NOTE:
To avoid routing loops, configure all the routers to be either compatible or incompatible with the external
route selection rules defined in RFC 1583.
Logging neighbor state changes
Follow these steps to enable the logging of neighbor state changes:
To do… Use the command…
Remarks
Enter system view system-view
—
Enter OSPF view
ospf [ process-id | router-id router-id |
vpn-instance instance-name ] *
—
Enable the logging of neighbor
state changes
log-peer-change
Optional
Enabled by default
Configuring OSPF network management
With trap generation enabled, OSPF generates traps to report important events. Traps fall into the
following levels.