R3166-R3206-HP High-End Firewalls Network Management Configuration Guide-6PW101

300
To do… Use the command… Remarks
Display OSPF retransmission
queue information
display ospf [ process-id ] retrans-queue
[ interface-type interface-number ] [ neighbor-id ]
Display OSPF ABR and ASBR
information
display ospf [ process-id ] abr-asbr
Display OSPF interface information
display ospf [ process-id ] interface [ all | interface-type
interface-number ]
Display OSPF error information display ospf [ process-id ] error
Display OSPF ASBR
summarization information
display ospf [ process-id ] asbr-summary [ ip-address
{ mask | mask-length } ]
Display the global router ID display router id
Reset OSPF counters
reset ospf [ process-id ] counters [ neighbor
[ interface-type interface-number ] [ router-id ] ]
Available in
user view
Reset an OSPF process reset ospf [ process-id ] process
Re-enable OSPF route
redistribution
reset ospf [ process-id ] redistribution
OSPF basic functions configuration example
Network requirements
• As shown in Figure 162, all routers run OSPF. The AS is split into three areas, in which, Router A and
Router B act as ABRs.
• After configuration, all routers can learn routes to every network segment in the AS.
Figure 162 Network diagram for OSPF basic configuration
Configuration procedure
1. Configure IP addresses for interfaces (omitted).
2. Configure OSPF basic functions.
# Configure Router A.
<RouterA> system-view
[RouterA] ospf
[RouterA-ospf-1] area 0
[RouterA-ospf-1-area-0.0.0.0] network 10.1.1.0 0.0.0.255