R3166-R3206-HP High-End Firewalls Network Management Configuration Guide-6PW101

31
To do… Use the command… Remarks
Enter
interface
view
Enter
Ethernet
interface
view
interface interface-type
interface-number
Required
Use either command.
• The configuration made in Ethernet
interface view applies only to the
port.
• The configuration made in Layer 2
aggregate interface view applies to
the aggregate interface and its
aggregation member ports. If the
system fails to apply the
configuration to the aggregate
interface, it stops applying the
configuration to aggregation
member ports. If the system fails to
apply the configuration to an
aggregation member port, it skips
the port and moves to the next
member port.
Enter Layer
2
aggregate
interface
view
interface bridge-aggregation
interface-number
Configure the link type of
the ports as access
port link-type access
Optional
By default, all ports are access ports.
Assign the access ports to
a VLAN
port access vlan vlan-id
Optional
By default, all access ports belong to
VLAN 1.
NOTE:
• Before assigning an access port to a VLAN, create the VLAN first.
• In VLAN view, only Layer 2 Ethernet interfaces can be assigned to the VLAN.
• The link type of Layer 2 Ethernet subinterfaces is fixed at access. You can assign them to a VLAN in
either of the preceding approaches.
Assigning a trunk port to a VLAN
A trunk port can carry multiple VLANs. You can assign it to a VLAN in interface view (including Ethernet
interface view and Layer 2 aggregate interface view).
Follow these steps to assign a trunk port to one or multiple VLANs:
To do… Use the command…
Remarks
Enter system view system-view —