R3166-R3206-HP High-End Firewalls Network Management Configuration Guide-6PW101

412
Network diagram
Figure 209 Network diagram for basic IGMP functions configuration
Configuration procedure
1. Configure IP addresses and unicast routing
Configure the IP address and subnet mask of each interface as per Figure 209. T
he detailed
configuration steps are omitted here.
Configure the OSPF protocol for interoperation on the PIM network. Ensure the network-layer
interoperation on the PIM network and dynamic update of routing information among the devices
through a unicast routing protocol. The detailed configuration steps are omitted here.
2. Enable IP multicast routing, and enable PIM-DM and IGMP
# On Firewall A, enable IP multicast routing, enable PIM-DM on each interface, and enable IGMP on
GigabitEthernet 0/1.
• After logging into the Web interface of Firewall A, select Network > Routing Management >
Multicast Routing from the navigation tree to enter the Global Configuration page.
Figure 210 Global configuration page
• Select Enable from the drop-down list to enable multicast routing.
• Click Apply.
• Select Network > Routing Management > PIM from the navigation tree to enter the Interface
Configuration page.
• Click the icon corresponding to GigabitEthernet 0/1 to enter its configuration page.