R3166-R3206-HP High-End Firewalls Network Management Configuration Guide-6PW101

32
To do… Use the command… Remarks
Enter
interface
view
Enter
Ethernet
interface
view
interface interface-type
interface-number
Required
Use either command.
• The configuration made in Ethernet
interface view applies only to the
port.
• The configuration made in Layer 2
aggregate interface view applies to
the aggregate interface and its
aggregation member ports. If the
system fails to apply the
configuration to the aggregate
interface, it stops applying the
configuration to aggregation
member ports. If the system fails to
apply the configuration to an
aggregation member port, it skips
the port and moves to the next
member port.
Enter Layer
2
aggregate
interface
view
interface bridge-aggregation
interface-number
Configure the link type of
the ports as trunk
port link-type trunk
Required
By default, all ports are access ports.
Assign the trunk ports to the
specified VLANs
port trunk permit vlan { vlan-id-list |
all }
Required
By default, a trunk port carries only
VLAN 1.
Configure the PVID of the
trunk ports
port trunk pvid vlan vlan-id
Optional
By default, the PVID is VLAN 1.
NOTE:
• To chan
g
e the link type of a port from trunk to hybrid or vice versa, you must set the link type to access
first.
• After configuring the PVID for a trunk port, you must use the port trunk permit vlan command to
configure the trunk port to allow packets from the PVID to pass through, so that the egress port can
forward packets from the PVID.
Assigning a hybrid port to a VLAN
A hybrid port can carry multiple VLANs. You can assign it to a VLAN in interface view (including Ethernet
interface view and Layer 2 aggregate interface view).
Follow these steps to assign a hybrid port to one or multiple VLANs:
To do… Use the command…
Remarks
Enter system view system-view —