R3166-R3206-HP High-End Firewalls Network Management Configuration Guide-6PW101

426
[FirewallA] multicast routing-enable
[FirewallA] interface gigabitEthernet 0/1
[FirewallA-GigabitEthernet0/1] igmp enable
[FirewallA-GigabitEthernet0/1] pim dm
[FirewallA-GigabitEthernet0/1] quit
[FirewallA] interface gigabitEthernet 0/0
[FirewallA-GigabitEthernet0/0] pim dm
[FirewallA-GigabitEthernet0/0] quit
# Enable IP multicast routing on Firewall B, enable PIM-DM on each interface, and enable IGMP on
GigabitEthernet 0/1.
<FirewallB> system-view
[FirewallB] multicast routing-enable
[FirewallB] interface gigabitEthernet 0/1
[FirewallB-GigabitEthernet0/1] igmp enable
[FirewallB-GigabitEthernet0/1] pim dm
[FirewallB-GigabitEthernet0/1] quit
[FirewallB] interface gigabitEthernet 0/0
[FirewallB-GigabitEthernet0/0] pim dm
[FirewallB-GigabitEthernet0/0] quit
# Enable IP multicast routing on Firewall C, enable PIM-DM on each interface, and enable IGMP on
GigabitEthernet 0/1.
<FirewallC> system-view
[FirewallC] multicast routing-enable
[FirewallC] interface gigabitEthernet 0/1
[FirewallC-GigabitEthernet0/1] igmp enable
[FirewallC-GigabitEthernet0/1] pim dm
[FirewallC-GigabitEthernet0/1] quit
[FirewallC] interface gigabitEthernet 0/0
[FirewallC-GigabitEthernet0/0] pim dm
[FirewallC-GigabitEthernet0/0] quit
3. Verify the configuration
Use the display igmp interface command to view the IGMP configuration and operation status on each
firewall interface. For example:
# Display IGMP information on GigabitEthernet 0/1 of Firewall B.
[FirewallB] display igmp interface GigabitEthernet 0/1
GigabitEthernet0/1(10.110.2.1):
IGMP is enabled
Current IGMP version is 2
Value of query interval for IGMP(in seconds): 60
Value of other querier present interval for IGMP(in seconds): 125
Value of maximum query response time for IGMP(in seconds): 10
Querier for IGMP: 10.110.2.1 (this Firewall)
Total 1 IGMP Group reported