R3166-R3206-HP High-End Firewalls Network Management Configuration Guide-6PW101

438
Network diagram
Figure 221 Network diagram for PIM-DM configuration
Configuration procedure
1. Configure IP addresses and unicast routing
Configure the IP address for each interface as per Figure 221 and co
nfigure the security zone. Detailed
configuration steps are omitted here.
Configure the OSPF protocol for interoperation in the PIM-DM domain. Ensure the network-layer
interoperation in the PIM-DM domain and enable dynamic update of routing information through a
unicast routing protocol. Detailed configuration steps are omitted here.
2. Enable IP multicast routing, and enable PIM-DM and IGMP
# On Firewall A, enable IP multicast routing, enable PIM-DM on each interface, and enable IGMP on
GigabitEthernet 1/1, which connects to N1.
• After logging into the Web interface of Firewall A, select Network > Routing Management >
Multicast Routing from the navigation tree to enter the Global Configuration page.
Figure 222 Global configuration page
• Select Enable from the drop-down list to enable multicast routing.
• Click Apply.
• Select Network > Routing Management > IGMP from the navigation tree to enter the Interface
Configuration page.
• Click the icon corresponding to GigabitEthernet 0/1 to enter its configuration page.