R3166-R3206-HP High-End Firewalls Network Management Configuration Guide-6PW101

442
To do... Use the command... Remarks
Enter public instance PIM view pim —
Configure the interval between
state-refresh messages
state-refresh-interval interval
Optional
60 seconds by default
Configure the time to wait before
receiving a new state-refresh
message
state-refresh-rate-limit interval
Optional
30 seconds by default
Configure the TTL value of
state-refresh messages
state-refresh-ttl ttl-value
Optional
255 by default
Configuring PIM-DM graft retry period
In PIM-DM, graft is the only type of message that uses the acknowledgment mechanism. In a PIM-DM
domain, if a router does not receive a graft-ack message from the upstream router within the specified
time after it sends a graft message, the router keeps sending new graft messages at a configurable
interval, namely graft retry period, until it receives a graft-ack from the upstream router.
Follow these steps to configure graft retry period:
To do... Use the command... Remarks
Enter system view system-view —
Enter interface view
interface interface-type
interface-number
—
Configure graft retry period pim timer graft-retry interval
Optional
3 seconds by default
NOTE:
For the configuration of other timers in PIM-DM, see “Configuring PIM common timers.”
Configuring PIM-SM
PIM-SM configuration task list
Complete these tasks to configure PIM-SM:
Task Remarks
Configuring PIM-SM Required
Configuring an RP
Configuring a static RP Optional
Configuring a C-RP Optional
Enabling auto-RP Optional
Configuring C-RP timers globally Optional
Configuring a BSR
Configuring a C-BSR Optional
Configuring a PIM domain border Optional
Configuring global C-BSR parameters Optional
Configuring C-BSR timers Optional