R3166-R3206-HP High-End Firewalls Network Management Configuration Guide-6PW101

35
GigabitEthernet0/3
Untagged Ports:
GigabitEthernet0/1
[FirewallA-GigabitEthernet0/3] display vlan 200
VLAN ID: 200
VLAN Type: static
Route Interface: not configured
Description: VLAN 0200
Name: VLAN 0200
Broadcast MAX-ratio: 100%
Tagged Ports:
GigabitEthernet0/3
Untagged Ports:
GigabitEthernet0/2
Displaying and maintaining VLAN
To do... Use the command… Remarks
Display VLAN information
display vlan [ vlan-id1 [ to vlan-id2 ] |
all | dynamic | reserved | static ]
Available in any view
Display VLAN interface
information
display interface vlan-interface
vlan-interface-id
Available in any view
Display hybrid ports or
trunk ports on the device
display port { hybrid | trunk } Available in any view
Clear statistics on a port
reset counters interface vlan-interface
[ vlan-interface-id ]
Available in user view
Configuration guidelines
Follow these guidelines when configuring VLAN:
1. As the default VLAN, VLAN 1 cannot be created or removed
2. You cannot manually create or remove VLANs reserved for special purposes.
3. As shown in Figure 12, when you type a VLAN range in the VLAN Range text box and then click
Select, the table below lists information about all VLANs within this range, which makes the
operation much easier when the firewall contains a large number of VLANs. To remove all VLANs
within this range, click Delete.
4. Dynamic VLANs cannot be removed manually.