R3166-R3206-HP High-End Firewalls Network Management Configuration Guide-6PW101

472
Configure OSPF for interoperation among the devices in the PIM-SM domain. Ensure the network-layer
interoperation among the devices in the PIM-SM domain and enable dynamic update of routing
information among the devices through a unicast routing protocol. Detailed configuration steps are
omitted here.
2. Enable IP multicast routing and administrative scoping, and enable PIM-SM and IGMP
# Enable IP multicast routing and administrative scoping on Device A, enable PIM-SM on each interface,
and enable IGMP on the host-side interface GigabitEthernet 0/1.
<DeviceA> system-view
[DeviceA] multicast routing-enable
[DeviceA] pim
[DeviceA-pim] c-bsr admin-scope
[DeviceA-pim] quit
[DeviceA] interface GigabitEthernet 0/1
[DeviceA-GigabitEthernet0/1] igmp enable
[DeviceA-GigabitEthernet0/1] pim sm
[DeviceA-GigabitEthernet0/1] quit
[DeviceA] interface gigabitethernet 0/2
[DeviceA-Gigabitethernet 0/2] pim sm
[DeviceA-Gigabitethernet 0/2] quit
The configuration on Device E and Device I is similar to the configuration on Device A.
# On Firewall B, enable IP multicast routing and administrative scoping, and enable PIM-SM on each
interface.
<FirewallB> system-view
[FirewallB] multicast routing-enable
[FirewallB] pim
[FirewallB-pim] c-bsr admin-scope
[FirewallB-pim] quit
[FirewallB] interface gigabitethernet 0/1
[FirewallB-GigabitEthernet0/1] pim sm
[FirewallB-GigabitEthernet0/1] quit
[FirewallB] interface gigabitethernet 0/2
[FirewallB- GigabitEthernet0/2] pim sm
[FirewallB- GigabitEthernet0/2] quit
[FirewallB] interface gigabitethernet 0/3
[FirewallB- GigabitEthernet0/3] pim sm
[FirewallB- GigabitEthernet0/3] quit
[FirewallB] interface gigabitethernet 0/4
[FirewallB- GigabitEthernet0/4] pim sm
[FirewallB- GigabitEthernet0/4] quit
The configuration on Firewall C, Firewall D, Firewall F, Device G, and Device H is similar to the
configuration on Firewall B. The specific configuration steps are omitted here.
3. Configure an admin-scope zone boundary
# On Firewall B, configure GigabitEthernet0/3 and GigabitEthernet0/4 as the boundary of
admin-scope zone 1.
[FirewallB] interface gigabitethernet 0/3
[FirewallB-GigabitEthernet0/3] multicast boundary 239.0.0.0 8