R3166-R3206-HP High-End Firewalls Network Management Configuration Guide-6PW101

484
NOTE:
A
ll the confi
g
uration tasks should be carried out on RPs in PIM-SM domains, and each of these RPs acts as
an MSDP peer..
Configuring basic functions of MSDP
NOTE:
A
ll the configuration tasks should be carried out on RPs in PIM-SM domains, and each of these RPs acts as
an MSDP peer.
Configuration prerequisites
Before configuring the basic functions of MSDP, complete the following tasks:
• Configure any unicast routing protocol so that all devices in the domain are interoperable at the
network layer.
• Configuring PIM-SM to enable intra-domain multicast forwarding.
Before configuring the basic functions of MSDP, prepare the following data:
• IP addresses of MSDP peers
• Address prefix list for an RP address filtering policy
Enabling MSDP
Enabling MSDP globally in the public instance
Follow these steps to enable MSDP globally in the public instance:
To do... Use the command... Remarks
Enter system view system-view —
Enable IP multicast routing multicast routing-enable
Required
Disabled by default
Enable MSDP and enter public
instance MSDP view
msdp
Required
Disabled by default
Creating an MSDP peer connection
An MSDP peering relationship is identified by an address pair, namely the address of the local MSDP
peer and that of the remote MSDP peer. An MSDP peer connection must be created on both devices that
are a pair of MSDP peers.
Follow these steps to create an MSDP peer connection:
To do... Use the command... Remarks
Enter system view system-view —
Enter public instance MSDP view msdp —