R3166-R3206-HP High-End Firewalls Network Management Configuration Guide-6PW101

485
To do... Use the command... Remarks
Create an MSDP peer
connection
peer peer-address connect-interface
interface-type interface-number
Required
No MSDP peer connection created
by default
NOTE:
If an interface of the router is shared by an MSDP peer and a BGP/MBGP peer at the same time, we
recommend that you use the IP address of the BGP/MBGP peer as the IP address of the for the MSDP peer.
Configuring a static RPF peer
Configuring static RPF peers avoids RPF check of SA messages.
Follow these steps to configure a static RPF peer:
To do... Use the command... Remarks
Enter system view system-view —
Enter public instance MSDP view msdp —
Configure a static RPF peer
static-rpf-peer peer-address
[ rp-policy ip-prefix-name ]
Required
No static RPF peer configured by
default
NOTE:
If only one MSDP peer is configured on a router, this MSDP will be registered as a static RPF peer.
Configuring an MSDP peer connection
Configuration prerequisites
Before configuring MSDP peer connection, complete the following tasks:
• Configure any unicast routing protocol so that all devices in the domain are interoperable at the
network layer.
• Configuring basic functions of MSDP
Before configuring an MSDP peer connection, prepare the following data:
• Description information of MSDP peers
• Name of an MSDP mesh group
• MSDP peer connection retry interval
Configuring MSDP peer description
With the MSDP peer description information, the administrator can easily distinguish different MSDP
peers and thus better manage MSDP peers.
Follow these steps to configure description for an MSDP peer: