R3166-R3206-HP High-End Firewalls Network Management Configuration Guide-6PW101
499
[FirewallE-msdp] static-rpf-peer 192.168.3.1 rp-policy list-c
[FirewallE-msdp] quit
5. Verify the configuration
Carry out the display bgp peer command to view the BGP peering relationships between the devices. If
the command gives no output information, a BGP peering relationship has not been established between
the devices.
When the multicast source in PIM-SM 1 (Source 1) and the multicast source in PIM-SM 2 (Source 2) send
multicast information, receivers in PIM-SM 1 and PIM-SM 3 can receive the multicast data. You can use
the display msdp brief command to view the brief information of MSDP peering relationships between
the devices. For example:
# View the brief MSDP peer information on Firewall B.
[FirewallB] display msdp brief
MSDP Peer Brief Information of VPN-Instance: public net
Configured Up Listen Connect Shutdown Down
2 2 0 0 0 0
Peer's Address State Up/Down time AS SA Count Reset Count
192.168.3.2 Up 01:07:08 ? 8 0
192.168.1.2 Up 00:16:39 ? 13 0
# View the brief MSDP peer information on Firewall C.
[FirewallC] display msdp brief
MSDP Peer Brief Information of VPN-Instance: public net
Configured Up Listen Connect Shutdown Down
1 1 0 0 0 0
Peer's Address State Up/Down time AS SA Count Reset Count
192.168.1.1 Up 01:07:09 ? 8 0
# View the brief MSDP peer information on Firewall E.
[FirewallE] display msdp brief
MSDP Peer Brief Information of VPN-Instance: public net
Configured Up Listen Connect Shutdown Down
1 1 0 0 0 0
Peer's Address State Up/Down time AS SA Count Reset Count
192.168.3.1 Up 00:16:40 ? 13 0
Anycast RP configuration
Network requirements
• The PIM-SM domain in this example has multiple multicast sources and receivers. OSPF runs within
the domain to provide unicast routes.
• It is required to configure the anycast RP application so that the receiver-side DRs and the
source-side DRs can initiate a Join message to their respective RPs that are the topologically nearest
to them.
• On Firewall B and Firewall D, configure the interface Loopback 10 as a C-BSR, and Loopback 20
as a C-RP.