R3166-R3206-HP High-End Firewalls Network Management Configuration Guide-6PW101

500
• The Firewall ID of Firewall B is 1.1.1.1, while the Firewall ID of Firewall D is 2.2.2.2. Set up an MSDP
peering relationship between Firewall B and Firewall D.
Network diagram
Figure 232 Network diagram for anycast RP application configuration
Device Interface IP address Device Interface IP address
Source 1 — 10.110.5.100/24 Device C GE0/0 192.168.1.2/24
Source 2 — 10.110.6.100/24 GE0/1 192.168.2.2/24
Device A GE0/1 10.110.5.1/24 Firewall D GE0/1 10.110.3.1/24
GE0/3 10.110.2.2/24 GE0/3 10.110.4.1/24
Firewall B GE0/1 10.110.1.1/24 GE0/0 192.168.2.1/24
GE0/3 10.110.2.1/24 Loop0 2.2.2.2/32
GE0/0 192.168.1.1/24 Loop10 4.4.4.4/32
Loop0 1.1.1.1/32 Loop20 10.1.1.1/32
Loop10 3.3.3.3/32 Device E GE0/1 10.110.6.1/24
Loop20 10.1.1.1/32 GE0/1 10.110.4.2/24
Configuration procedure
1. Configure IP addresses and unicast routing
Configure the IP address and subnet mask for each interface as per Figure 232.
Detailed configuration
steps are omitted.
Configure OSPF for interconnection between the devices in the PIM-SM domain. Ensure the network-layer
interoperation among the devices, and ensure the dynamic update of routing information through a
unicast routing protocol. Detailed configuration steps are omitted.
2. Enable IP multicast routing, and enable PIM-SM and IGMP
# Enable IP multicast routing on Firewall B, enable PIM-SM on each interface, and enable IGMP on the
host-side interface GigabitEthernet 0/1.
<FirewallB> system-view
Loop10
L
o
o
p
0
L
o
o
p
2
0
Loop10
L
o
o
p
2
0
L
o
o
p
0
Receiver
Source 1
Device A
Firewall B
Device C
Firewall D
Device E
P
O
S
5
/
0
P
O
S
5
/
0
P
O
S
5
/
1
P
O
S
5
/
0
Eth1/1
S
2
/
0
S
2
/
0
S
2
/
0
S
2
/
0
Eth1/1
Receiver
Source 2
PIM-SM
MSDP peers
Eth1/1 Eth1/1
Host A Host B