R3166-R3206-HP High-End Firewalls System Management and Maintenance Command Reference-6PW101

108
ntp-service broadcast-client
Syntax
ntp-service broadcast-client
undo ntp-service broadcast-client
View
Interface view
Default level
2: System level
Parameters
None
Description
Use the ntp-service broadcast-client command to configure the device to work in the NTP broadcast
client mode and use the current interface to receive NTP broadcast packets.
Use the undo ntp-service broadcast-client command to remove the configuration.
By default, the device does not work in the NTP broadcast client mode.
Examples
# Configure the device to work in the broadcast client mode and receive NTP broadcast messages on
GE0/1.
<Sysname> system-view
[Sysname] interface gigabitethernet 0/1
[Sysname-GigabitEthernet0/1] ntp-service broadcast-client
ntp-service broadcast-server
Syntax
ntp-service broadcast-server [ authentication-keyid keyid | version number ] *
undo ntp-service broadcast-server
View
Interface view
Default level
2: System level
Parameters
authentication-keyid keyid: Specifies the key ID to be used for sending broadcast messages to broadcast
clients, where keyid is in the range of 1 to 4294967295. This parameter is not meaningful if
authentication is not required.
version number: Specifies the NTP version, where number is in the range of 1 to 3 and defaults to 3.
Description
Use the ntp-service broadcast-server command to configure the device to work in the NTP broadcast
server mode and use the current interface to send NTP broadcast packets.