R3166-R3206-HP High-End Firewalls System Management and Maintenance Command Reference-6PW101

7
Description
Use the debugging command to enable the debugging of a specific module.
Use the undo debugging command to disable the debugging of a specific module.
By default, debugging functions of all modules are disabled.
Note the following:
• Output of the debugging information may degrade system efficiency, so HP recommends that you
enable the debugging of the corresponding module for diagnosing network failure, and not to
enable the debugging of multiple modules at the same time.
• Default level describes the default level of the debugging all command. Different debugging
commands may have different default levels.
• You must configure the debugging, terminal debugging and terminal monitor commands first to
display detailed debugging information on the terminal.
Related commands: display debugging.
Examples
# Enable IP packet debugging.
<Sysname> debugging ip packet
display debugging
Syntax
display debugging [ interface interface-type interface-number ] [ module-name ]
View
Any view
Default level
1: Monitor level
Parameters
interface interface-type interface-number: Displays the debugging settings of the specified interface,
where interface-type interface-number represents the interface type and number.
module-name: Module name.
Description
Use the display debugging command to display enabled debugging functions.
Related commands: debugging.
Examples
# Display all enabled debugging functions.
<Sysname> display debugging
IP packet debugging is on