R3166-R3206-HP High-End Firewalls System Management and Maintenance Command Reference-6PW101

59
Table 14 Output description
Field Descri
p
tion
The location of patches
Patch file location. To configure the location, use the patch location
command.
Slot Meaningless
Version
Patch version. The first three characters represent the suffix of the
PATCH-FLAG. For example, if the PATCH-FLAG of the a card is PATCH-RPE,
“RPE” is displayed. The following three digits, if any, represent the patch
number. (The patch number can be read after the patch is loaded.)
Temporary Number of temporary patches
Common Number of common patches
Current Total number of patches
Running Number of patches in the RUNNING state
Active Number of patches in the ACTIVE state
Start-Address Starting address of the memory patch area in the memory
patch active
Syntax
patch active [ patch-number ]
View
System view
Default level
3: Manage level
Parameters
patch-number: Sequence number of a patch.
Description
Use the patch active command to activate patches. The system will temporarily run the loaded patches.
• If you execute the command with specifying the sequence number of a patch, all the DEACTIVE
patches (including the specified patch) before the specified patch will be activated.
• If you execute the command without specifying the sequence number of a patch, all the DEACTIVE
patches will be activated.
NOTE:
• The command is applicable to only patches in the DEACTIVE state.
• After a system reboot, the original ACTIVE patches change to DEACTIVE and become invalid. To make
them effective, activate them again.
Examples
# Activate patch 3 and all the loaded DEACTIVE patches before patch 3.
<Sysname> system-view