R3166-R3206-HP High-End Firewalls System Management and Maintenance Command Reference-6PW101

81
By default, output of system information to the SNMP module is enabled with a default channel name of
snmpagent and a default channel number of 5. For more information, see the display snmp-agent
command.
Examples
# Output system information to the SNMP module through channel 6.
<Sysname> system-view
[Sysname] info-center snmp channel 6
info-center source
Syntax
info-center source { module-name | default } channel { channel-number | channel-name } [ debug { level
severity | state state } * | log { level severity | state state } * | trap { level severity | state state } * ] *
undo info-center source { module-name | default } channel { channel-number | channel-name }
View
System view
Default level
2: System level
Parameters
module-name: Specifies the output rules of the system information of the specified modules. For instance,
if information on ARP module is to be output, you can configure this argument as ARP. You can use the
info-center source ? command to view the modules supported by the device.
default: Specifies the output rules of the system information of all the modules allowed to output the
system information, including all the modules displayed by using the info-center source ? command.
debug: Debugging information.
log: Log information.
trap: Trap information.
level severity: Specifies the severity of system information. For more information, see Table 18. W
ith this
keyword, you can specify the severity level of the information allowed/denied to output.
state state: Configures whether to output the system information, which could be on (enabled) or off
(disabled). With this keyword, you can specify whether to output the specified system information.
channel-number: Specifies a channel number, in the range 0 to 9.
channel-name: Specifies a channel name, which could be a default name or a self-defined name. The
user needs to specify a channel name first before using it as a self-defined channel name. For more
information, see the info-center channel name command.
Description
Use the info-center source command to specify the output rules of the system information.
Use the undo info-center source command to remove the specified output rules.
By default, the output rules for the system information are listed in Table 23.
T
his command can be used to set the filter and redirection rules of log, trap and debugging information.