R3166-R3206-HP High-End Firewalls System Management and Maintenance Configuration Guide-6PW101

120
Follow these steps to configure SNMPv1 and SNMPv2c:
To do… Use the command…
Remarks
Enter system view system-view —
Enable the SNMP agent snmp-agent
Optional
Disabled by default
You can also enable the SNMP
agent service by using any
command that begins with
snmp-agent except the snmp-agent
calculate-password command
Configure SNMP agent system
information
snmp-agent sys-info { contact
sys-contact | location sys-location
| version { { v1 | v2c | v3 }* |
all } }
Required
The defaults are as follows:
null for contact;
null for location, and SNMP v3 for
the version.
Configure a local engine ID for an
SNMP entity
snmp-agent local-engineid
engineid
Optional
Company ID and device ID by
default.
Create or update MIB view content
for an SNMP agent
snmp-agent mib-view { excluded |
included } view-name oid-tree
[ mask mask-value ]
Optional
The MIB view name is ViewDefault
and OID is 1 by default.
Configur
e SNMP
NMS
access
right
Configur
e directly
Create
an SNMP
communit
y
snmp-agent community { read |
write } community-name [ acl
acl-number | mib-view
view-name ]*
Use either approach.
Both commands can be used to
configure SNMP NMS access
rights. The second command was
introduced to be compatible with
SNMPv3.
The community name configured on
the NMS should be consistent with
the username configured on the
agent.
Configur
e
indirectly
Configur
e an
SNMP
group
snmp-agent group { v1 | v2c }
group-name [ read-view
read-view ] [ write-view
write-view ] [ notify-view
notify-view ] [ acl acl-number ]
Add a
user to an
SNMP
group
snmp-agent usm-user { v1 | v2c }
user-name group-name [ acl
acl-number ]
Configure the maximum size of an
SNMP packet that can be received
or sent by an SNMP agent
snmp-agent packet max-size
byte-count
Optional
1,500 bytes by default.
CAUTION:
• The validity of a USM user depends on the engine ID of the SNMP agent. If the engine ID generated
when the USM user is created is not identical to the current engine ID, the USM user is invalid.
• A MIB view is a subset of MIB and is uniquely identified by its view name and the MIB subtree to
g
ether.
MIB views with the same view name but containing different subtrees are considered different views.
Except default MIB views, you can create at most 16 MIB views.