R3166-R3206-HP High-End Firewalls System Management and Maintenance Configuration Guide-6PW101

127
# Enable logging display on the terminal. (This function is enabled by default, so that you can omit this
configuration).
<Sysname> terminal monitor
<Sysname> terminal logging
# Enable the information center to output the system information with the severity level equal to or higher
than informational to the console port.
<Sysname> system-view
[Sysname] info-center source snmp channel console log level informational
# Enable SNMP logging on the agent to log the GET and SET operations of the NMS.
[Sysname] snmp-agent log get-operation
[Sysname] snmp-agent log set-operation
• The following log information is displayed on the terminal when the NMS performs the Get
operation to the agent.
%Jan 1 02:49:40:566 2006 Sysname SNMP/6/GET:
-seqNO=10-srcIP=1.1.1.2-op=GET-node=sysName(1.3.6.1.2.1.1.5.0)-value=; The agent
received a message.
• The following log information is displayed on the terminal when the NMS performs the Set
operation to the agent.
%Jan 1 02:59:42:576 2006 Sysname SNMP/6/SET:
-seqNO=11-srcIP=1.1.1.2-op=SET-errorIndex=0-errorStatus=noError-node=sysName(1.3.6.1.
2.1.1.5.0)-value=Sysname; The agent received a message.
Table 27 Description on the output field of SNMP log
Field Descri
p
tion
Jan 1 02:49:40:566 2006 The time when the SNMP log is generated
seqNO
Serial number of the SNMP log (The system numbers the recorded SNMP
logs automatically; the serial number starts from 0)
srcIP IP address of the NMS
op SNMP operation type (GET or SET)
node Node name of the SNMP operations and OID of the instance
erroIndex Error index, with 0 meaning no error
errorstatus Error status, with noError meaning no error
value
Value set when the SET operation is performed (This field is null, meaning
the value obtained with the GET operation is not logged.)
When the value is a string of characters and the string contains characters
not in the range of ASCII 0 to 127 or invisible characters, the string is
displayed in hexadecimal. For example, value = <81-43>[hex]
NOTE:
The system information of the information center can be output to the terminal or to the lo
g
buffer. In this
example, SNMP log is output to the terminal. For more information about SNMP log output to other
destinations, see the chapter “Information center configuration.”