R3166-R3206-HP High-End Firewalls System Management and Maintenance Configuration Guide-6PW101

30
To do… Use the command… Remarks
Enter system view system-view —
Set configuration rollback configuration replace file filename Required
CAUTION:
Do not unplug and plug a card during configuration rollback (that is, the system is executing the
configuration replace file command). Confi
g
uration rollback may fail if one of the followin
g
situations is
present (if a command cannot be rolled back, the system skips it and processes the next one):
• The actual undo form of a command differs from the complete undo form of the command. When the
configuration is rolled back, the system automatically performs the complete undo form of the
command, which cannot be recognized, and the configuration rollback fails.
• The configuration cannot be removed, such as hardware-related commands
• Commands in different views are dependent on each other
• If the replacement configuration file is not a complete file generated by using the save or archive
configuration command, or the file is copied from a different type of device, the confi
g
uration cannot be
rolled back. Ensure that the replacement configuration file is correct and compatible with the current
device.
Specifying a startup configuration file for the next
system startup
To specify a startup configuration file to be used at the next system startup, you can:
• Use the save command. If you save the running configuration to the specified configuration file in
the interactive mode, the system automatically sets the file as the main startup configuration file to
be used at the next system startup.
• Use the command dedicated to specify a startup configuration file to be used at the next startup,
which is described in the following table:
Follow the step below to specify a configuration file as the startup configuration file for the next system
startup:
To do… Use the command…
Remarks
Specify a startup configuration file
for the next system startup
startup saved-configuration cfgfile
Required
Available in user view
CAUTION:
A
configuration file must use .cfg as its extension name. The startup configuration file must be saved in the
root directory of the storage media.