R3166-R3206-HP High-End Firewalls System Management and Maintenance Configuration Guide-6PW101

40
Patches in the DEACTIVE state have been loaded to the memory patch area but have not run in the system
yet. Suppose that there are seven patches in the patch file to be loaded. After the seven patches
successfully pass the version check and CRC check, they are loaded to the memory patch area and are
in the DEACTIVE state. At this time, the patch states in the system are as shown in Figure 14.
Figure 14 A patch file is loaded to the memory patc
h area
3. ACTIVE state
Patches in the ACTIVE state are those that have run temporarily in the system and become DEACTIVE after
system reboot. For the seven patches in Figure 14, if y
ou activate the first five patches, their states change
from DEACTIVE to ACTIVE. At this time, the patch states in the system are as shown in Figure 15.
T
he patches that are in the ACTIVE state are in the DEACTIVE state after system reboot.
Figure 15 Patches are activated
4. RUNNING state
After you confirm the running of the ACTIVE patches, the state of the patches become RUNNING and
are in the RUNNING state after system reboot. For the five patches in Figure 15, if y
ou confirm running
the first three patches, their states change from ACTIVE to RUNNING. At this time, the patch states of the
system are as shown in Figure 16.
T
he patches that are in the RUNNING state are still in the RUNNING state after system reboot.