R3166-R3206-HP High-End Firewalls System Management and Maintenance Configuration Guide-6PW101

After you execute the command, the system displays the message “Do you want to continue running

patches after reboot? [Y/N]:”.

• Entering y or Y: All the specified patches are installed, and turn to the RUNNING state from IDLE.

This equals execution of the commands patch location, patch load, patch active, and patch run.

The patches remain RUNNING after system reboot.

• Entering n or N: All the specified patches are installed and turn to the ACTIVE state from IDLE. This

equals execution of the commands patch location, patch load and patch active. The patches turn to

the DEACTIVE state after system reboot.

Follow these steps to install the patches in one step:

To do… Use the

command…

Remarks

Enter system view system-view —

Install the patches in one step patch install patch-location Required

NOTE:

• The patch matches the card type and software version.

• If you install a patch file by specifying the directory where the patch file locates, the patch install

command will change the patch file location specified with the patch location command to the director

specified by the

patch-location

argument of the patch install command.

• To uninstall all patches in one operation, use the undo patch install command, which is the same as

performing Uninstalling a patch step-by-step.

Installing a patch step-by-step

Step-by-step patch installation enables you to control the patch status during the patch installation

process.

1. Step-by-step patch installation task list

Task Remarks

Configuring the patch file location

Optional

To install a patch package, skip this step.

Loading a patch file Required

Activating patches Required

Confirming running patches Optional

2. Configuring the patch file location

If you save the patch files to another storage media except the Flash on the device, you need to specify

the directory where the patch files locate with the patch-location argument. Then the system loads the

appropriate patch files from the specified directory. If the device has only one storage media, you do not

need to execute this command.

Follow these steps to configure the patch file location:

To do… Use the

command…

Remarks

Enter system view system-view —