R3166-R3206-HP High-End Firewalls System Management and Maintenance Configuration Guide-6PW101

54
Enabling the display of system information on a monitor terminal
After setting to output system information to a monitor terminal, you need to enable the associated
display function in order to display the output information on the monitor terminal.
Follow these steps to enable the display of system information on a monitor terminal:
To do… Use the command…
Remarks
Enable the monitoring of system
information on a monitor terminal
terminal monitor
Required
Enabled on the console and disabled on the
monitor terminal by default.
Enable the display of debugging
information on a monitor terminal
terminal debugging
Required
Disabled by default
Enable the display of log
information on a monitor terminal
terminal logging
Optional
Enabled by default
Enable the display of trap
information on a monitor terminal
terminal trapping
Optional
Enabled by default
Outputting system information to a log host
To do… Use the command… Remarks
Enter system view system-view —
Enable information center info-center enable
Optional
Enabled by default
Name the channel with a
specified channel number
info-center channel
channel-number name
channel-name
Optional
For default channel names, see Table 9.
Specify a log host and configure
the parameters when system
information is output to the log
host
info-center loghost host-ip
[ port port-number ] [ channel
{ channel-number |
channel-name } | facility
local-number ] *
Required
By default, the system does not output
information to a log host. If you specify to
output system information to a log host,
the system uses channel 2 (loghost) by
default.
The value of the port-number argument
should be the same as the value
configured on the log host, otherwise, the
log host cannot receive system
information.
Configure the output rules of the
system information
info-center source
{ module-name | default }
channel { channel-number |
channel-name } [ debug { level
severity | state state } * | log
{ level severity | state state } *
| trap { level severity | state
state } * ] *
Optional
See “Default output rules of system
informa
tion.”