R3166-R3206-HP High-End Firewalls System Management and Maintenance Configuration Guide-6PW101

56
To do… Use the command… Remarks
Enter system view system-view —
Enable information center info-center enable
Optional
Enabled by default.
Name the channel with a
specified channel number
info-center channel channel-number
name channel-name
Optional
For default channel names, see Table 9.
Configure the channel
through which system
information can be output
to the log buffer and
specify the buffer size
info-center logbuffer [ channel
{ channel-number | channel-name }
| size buffersize ] *
Optional
By default, system information is output to
the log buffer through channel 4 (known
as logbuffer) and the default buffer size is
512.
Configure the output rules
of the system information
info-center source { module-name |
default } channel { channel-number
| channel-name } [ debug { level
severity | state state } * | log { level
severity | state state } * | trap { level
severity | state state } * ] *
Optional
See “Default output rules of system
informa
tion.”
Configure the format of the
timestamp
info-center timestamp { debugging
| log | trap } { boot | date | none }
Optional
The time stamp format for log, trap and
debugging information is date by default.
Outputting system information to the SNMP module
NOTE:
The SNMP module receives the trap information only, and discards the log and debugging information
even if you have configured to output them to the SNMP module.
To monitor the device running status, trap information is usually sent to the SNMP network management
system (NMS). In this case, you need to configure to send traps to the SNMP module, and then set the
trap sending parameters for the SNMP module to further process traps. For more information, see the
chapter “SNMP configuration. ”
Follow these steps to configure to output system information to the SNMP module:
To do… Use the command…
Remarks
Enter system view system-view —
Enable information center info-center enable
Optional
Enabled by default
Name the channel with a specified
channel number
info-center channel
channel-number name
channel-name
Optional
For default channel names,
see Table 9.
Configure the channel through
which system information can be
output to the SNMP module
info-center snmp channel
{ channel-number |
channel-name }
Optional
By default, system information is
output to the SNMP module
through channel 5 (known as
snmpagent).