R3166-R3206-HP High-End Firewalls System Management and Maintenance Configuration Guide-6PW101

57
To do… Use the command… Remarks
Configure the output rules of the
system information
info-center source { module-name |
default } channel { channel-number
| channel-name } [ debug { level
severity | state state } * | log { level
severity | state state } * | trap
{ level severity | state state } * ] *
Optional
See “Default output rules of system
informati
on.”
Configure the format of the
timestamp
info-center timestamp { debugging
| log | trap } { boot | date | none }
Optional
The time stamp format for log, trap
and debugging information is date
by default.
Outputting system information to the web interface
This feature allows you to control whether to output system information to the Web interface and which
system information can be output to the Web interface. The Web interface provides abundant search
and sorting functions; therefore, if you configure to output the system information to the Web interface,
you can view system information by clicking corresponding tabs after logging in to the device through the
Web interface.
Follow these steps to set to output system information to the Web interface:
To do… Use the command…
Remarks
Enter system view system-view —
Enable information center info-center enable
Optional
Enabled by default.
Name the channel with a specified
channel number
info-center channel
channel-number name
channel-name
Optional
For default channel names,
see Table 9.
Configure the channel through
which system information can be
output to the Web interface
info-center syslog channel
{ channel-number |
channel-name }
Optional
By default, system information is
output to the Web interface
through channel 6.
Configure the output rules of the
system information
info-center source { module-name |
default } channel { channel-number
| channel-name } [ debug { level
severity | state state }* | log { level
severity | state state }* | trap
{ level severity | state state }* ]*
Optional
See “Default output rules of system
informati
on.”
Configure the format of the
timestamp
info-center timestamp { debugging
| log | trap } { boot | date | none }
Optional
The time stamp format for log, trap
and debugging information is date
by default.
NOTE:
You can configure to output log, trap and debugging information to a channel. However, when this
channel is bound with the output destination Web interface, after lo
gg
in
g
in throu
g
h the Web interface,
you can view log information of specific types only, and other types of information will be filtered out.