R3166-R3206-HP High-End Firewalls VPN Command Reference-6PW101

display interface tunnel

Syntax

display interface tunnel [ number ]

View

Any view

Default level

1: Monitor level

Parameters

number: Number of a tunnel interface. If no interface number is specified, information about all tunnel

interfaces will be displayed.

Description

Use the display interface tunnel command to display information about tunnel interfaces, including the

source address, destination address, and tunnel mode.

Related commands: interface tunnel, source, destination, tunnel-protocol.

Examples

# Display information about interface Tunnel 0.

<Sysname> display interface tunnel 0

Tunnel0 current state: UP

Line protocol current state: UP

Description: Tunnel0 Interface

The Maximum Transmit Unit is 64000

Internet Address is 10.1.2.1/24 Primary

Encapsulation is TUNNEL, service-loopback-group ID not set

Tunnel source 192.13.2.1, destination 192.13.2.2

Tunnel keepalive enabled, Period(50 s), Retries(3)

Tunnel protocol/transport GRE/IP

GRE key disabled

Checksumming of GRE packets disabled

Last clearing of counters: Never

Last 300 seconds input: 0 bytes/sec, 0 packets/sec

Last 300 seconds output: 0 bytes/sec, 0 packets/sec

361 packets input, 9953388 bytes

0 input error

361 packets output, 30324 bytes

0 output error