R3166-R3206-HP High-End Firewalls VPN Configuration Guide-6PW101

101
Item Descri
p
tion
IP Address Pool Number
Specify the number of the IP address pool.
If you set the IP address pool number to 1, the name of the IP address pool is
pool1.
Start IP
Specify the start IP address and end IP address of the IP address pool.
The number of addresses between the start IP address and end IP address
must not exceed 1024. If you specify only the start IP address, the IP address
pool will contain only one IP address, namely, the start IP address.
End IP
Return to L2TP configuration task list.
Displaying L2TP tunnel information
Select VPN > L2TP > Tunnel Info from the navigation tree to enter the L2TP tunnel information page, as
shown in Figure 63.
Figure 63 L2TP tunnel in
formation
Table 27 L2TP tunnel information
Item Descri
p
tion
Local Tunnel ID Local ID of the tunnel
Peer Tunnel ID Peer ID of the tunnel
Peer Tunnel Port Peer port of the tunnel
Peer Tunnel IP Peer IP address of the tunnel
Session Count Number of sessions on the tunnel
Peer Tunnel Name Peer name of the tunnel
Return to L2TP configuration task list.
Client-initiated VPN configuration example
Network requirements
As shown in Figure 64, a VPN user accesses the corporate headquarters as follows:
1. The user first connects to the Internet, and then initiates a tunneling request to the LNS directly.
2. After the LNS accepts the connection request, an L2TP tunnel is set up between the LNS and the
VPN user.
3. The VPN user communicates with the headquarters over the tunnel.