R3166-R3206-HP High-End Firewalls VPN Configuration Guide-6PW101

27
To do… Use the command… Remarks
Enter system view system-view —
Create an IKE proposal and enter
its view
ike proposal proposal-number Required
Specify an encryption algorithm for
the IKE proposal
encryption-algorithm { 3des-cbc |
aes-cbc [ key-length ] | des-cbc }
Optional
56-bit DES by default
Specify an authentication method
for the IKE proposal
authentication-method { pre-share
| rsa-signature }
Optional
Pre-shared key by default
Specify an authentication
algorithm for the IKE proposal
authentication-algorithm { md5 |
sha }
Optional
SHA1 by default
Specify a DH group for key
negotiation in phase 1
dh { group1 | group2 | group5 |
group14 }
Optional
group1, namely the 768-bit DH
group, by default
Set the ISAKMP SA lifetime for the
IKE proposal
sa duration seconds
Optional
86400 seconds by default
NOTE:
Before an ISAKMP SA expires, IKE negotiates a new SA to replace it. DH calculation in IKE negotiation
takes time, especially on low-end devices. To prevent SA updates from influencing normal
communication, set the lifetime greater than 10 minutes.
Configuring an IKE peer
For an IPsec policy that uses IKE, you must configure an IKE peer by performing the following tasks:
• Specify the IKE negotiation mode for the local end to use in IKE negotiation phase 1. If the IP
address of the remote end is obtained dynamically, the IKE negotiation mode of the local end must
be aggressive. When acting as the IKE negotiation responder, the local end uses the IKE
negotiation mode of the remote end.
• Specify the IKE proposals for the local end to use when acting as the IKE negotiation initiator. When
acting as the responder, the local end uses the IKE proposals configured in system view for
negotiation.
• Configure a pre-shared key for pre-shared key authentication or a PKI domain for digital signature
authentication.
• Specify the ID type for the local end to use in IKE negotiation phase 1. With pre-shared key
authentication, the ID type must be IP address for main mode IKE negotiation and can be IP address,
FQDN, or user FQDN for aggressive mode IKE negotiation.
• Specify the name or IP address of the local security gateway. You perform this task only when you
want to specify a special address, a loopback interface address, for example, as the local security
gateway address.
• Specify the name or IP address of the remote security gateway. For the local end to initiate IKE
negotiation, you must specify the name or IP address of the remote security gateway on the local
end so the local end can find the remote end.